TreadMill 1 hp 220 volt electric DC permanent magnet motor generator 12mm O

Description

Manta motor Etek type PMG Permanent Magnet Generator MAKE BUILD ELECTRIC CARS VEHICLES PANCAKE ELECTRIC MOTORS etek ELECTRIC ETEC MOTOR CYCLE PMG Permanent Magnet generator PMA wind turbine hydro power wind turbines mills Etek
GREAT FOR
WIND TURBINE PROJECTS
You are bidding on a 1 HP / 220 volt DC / 800 Watt peak electric motor.
Very powerful for it's size.
The 220V is the best model for low wind 12 volt and 24 volt
high wind
turbines with 6 Hornet blades no longer than the stock 59" diameter max.
For grid tie use only 10.8 - 30 volt model types that have a dump load built in and are rated for wind turbine use.
Can also be used for powering karts and bikes.
Can also be used for making Electricity (needs diode)
and changing a battery.
Great for wind or hydro.
Used for display - Open box model. Runs great. Never connected to power. Some dust.
https://youtu.be/vsptRQFu0ks
NOTE:
For wind or hydro power we recommend only our 115 or 220 volt models.
For go karts, mini bikes and cycles we recommend our 12, 24 and 48 volt
models that correspond to your battery bank voltage.
We also sell a 90 volt DC version great for DC water pumps and hydraulic motors
https://youtu.be/PzDN_jmQvzo
Specifications:
Motor length
3.5" diameter / 6" long.
7.5" over all length including shaft
220 volt model (800W peak)
- Peak Amps is Watts divided by volts.  W ÷ V = A
12mm shaft with 1.75 pitch threads with flat slot at shaft tip. THIS IS NOT A 3/4" SHAFT!
Shaft is 1.5" long with 3/4" long threaded end (12mm/1.75 pitch thread by 3/4" long)
Two 5/16" extra large mounting holes on the front of the motor.
5/16" NCT mounting holes are 2.874" from center to center (74mm)
3000rpm @ 12V / continuous duty at 75% of peak wattage.
Heavy 10 AWG wire to handle the amps with water resistant rubber boot.
A put-up and forget design! Expect decades of dependable service life.
Rain, ice and weather resistant electronics in sealed case (not for under water)
Long life graphite brushes. We sell replacement brushes and bearings.
Works for both CW or CCW rotations.
Epoxy/Lam rotor efficiency = 94.6%
(Brushed motors convert more electricity into usable horsepower)
Weighs ONLY 8.5 lbs.  (Almost 100 Watts Per Pound !)
Can be used as a generator, makes power when turned
(Requires 100 amp blocking diode)
Just Plug & Play -
No expensive motor controller needed -
https://youtu.be/N0DMqD6TKGw
Brush technology is older but they are very
quick and simple to replace in the field AND
brushed motors convert more electricity into
usable horsepower! -
PRODUCT IDEAS
BUILD ELECTRIC CARS / INVENT ELECTRIC BOATS / DESIGN ELECTRIC MOTORCYCLES / MINI BIKES /  GO KARTS / POWERED BICYCLES and WIND TURBINES
HOW TO MAKE A TREAD MILL MOTOR WIND TURBINE
Love these blades you were right, wow can they turn on, im getting up to 40
volts out of my indiana general dv pm motor,there scarey sometimes, im
putting it on youtube for all to see, thanks again
-uptick57